Changes contained in version 3.8.7 (10/19/2015)
    Change branding to Geist Cool AgileAir.
    Added ability to set capacity set point via SNMP.
    Fixed SNMPv3 traps sent unencrypted.

Changes contained in version 3.8.3 (5/29/2014)
    Added XML config upload/download to Test & Configure page.
    Fixed syslog settings not saving properly.

Changes contained in version 3.8.2 (3/31/2014)
    Added 'admin description' command to CLP.
    Added network link state information to CLP.
    Added network link speed and uptime information to web, data.xml, CLP.
    Added 'clock' commands to CLP.
    Added the ipForward.ipCidrRouteTable to SNMP.
    Added an SNMP enable/disable command to the CLP.
    Added NTP sync period to CLP 'report' command.
    Added uptime (in seconds) to CLP 'report' command.
    Report actual link speed and uptime information in mib-2 interfaces table.
    Fixed units sometimes becoming unresponsive to network communications under heavy traffic load.
    Fixed various SNMP entries not updating when the device's network address changed.
    Fixed an issue that caused SNMP to respond slowly on some units.
    Fixed newline formatting in various CLP messages.
    Fixed DM and RTAFHD3 sensors showing up as Unknown in the web interface and missing from SNMP if they were unplugged during bootup.
    Fixed an issue that could cause a DM to show up as "Too many DMs" and not show any data after a reboot.
    Fixed an issue that could cause units not to reboot during the firmware update process.
        Note: This fix takes effect the next time the unit is updated after installing this firmware or newer.
        Reverting to firmware prior to 3.8.2 will reintroduce this issue.
    Updated copyrights to 2014.

Changes contained in version 3.8.1 (6/26/2013)
    Note: Due to firmware structure changes it is not possible to load firmware
          older than v3.8.1 onto units that have been upgraded to v3.8.1 or newer.
    Note: Systems with AgileAir-branded firmware must be updated using the Geist ASU.
    Fixes EC hosts sending alarms in the wrong temperature unit after the user changes the device’s units.
    Added a Reboot button to the Test & Configure page.
    Performance improvements in the network driver.
    The “server” element’s “uptime” attribute now reports seconds instead of 10s of seconds in data.xml.
    The SNMP MIB-II Interfaces table now reports correct uptime and link speed information.
    New branding: “ODS by Geist.”
    Updated copyright to 2013.    

Changes contained in version 3.7.3 (8/22/2012)
    Change Pressure Error, Pressure Difference and Pressure Set Point to x1000 values in SNMP.
    Fixed some alarm checkboxes can't be unchecked.
    Fixed a formatting error in the datalog.csv file.
    Rebranded GEC systems to AgileAir.
    
Changes contained in version 3.7.1 (3/26/2012):
    Fixed an issue where the fan RPM could drop to 0 after a firmware update.
    Fixed SNMP stops working after some firmware updates.
    Fixed incorrect data in the data.xml file for DM meters.
    Increased maximum RPMs for all fan types. Capacity percentages may go down after this update but RPMs and flow rate are unaffected.
    Changed MIB definition name to avoid conflict with the R-Series v3 MIB.
    Fixed web pages disappearing when certain languages were selected.
    Updated Geist logo and contact information.